How to Wash Brushed Fleece Fabric

How to Wash Brushed Fleece Fabric

For the chocolate brown 320 g/m² brushed fleece from cutmyfabric, wash at 30°C with a gentle detergent that contains no bleach, set the final spin to 800 rpm or less, and air dry. These settings apply to this particular sweatshirt knit, which is 70% cotton and 30% polyester. For another fleece, check its own care instructions. If you have already sewn the garment, take any stricter requirements for prints, trims or ribbing into account.

Before cutting, check how the knit responds to washing

If you are making joggers, a small change in the length of the fabric can show up at the ankle. You can check for it before laying out the pattern. On a spare piece of fleece, mark a 20 cm square with loose stitches. Run one side along the length of the fabric and the other across its width. Leave a margin around the square so you can measure between the marks even if the cut edges curl.

Wash and dry the sample as you plan to wash the finished garment. Lay it flat without stretching it and measure each side again. If the length measures 19.6 cm, it has shortened by 2% in that direction. That is an example calculation; your own measurements tell you how your piece behaved. Prewash the length you intend to cut, then let it dry fully before placing your pattern pieces. If you are adding separate ribbed cuffs, prewash the ribbing according to its care instructions as well.

How to load the washing machine

Wash fleece with similar colours and smooth garments. Close zips, fasten hook-and-loop tabs and empty the pockets. Turn a finished sweatshirt or pair of joggers inside out to protect the smooth outer face. The brushed side will now be exposed, so keep rough denim and snagging fasteners out of the same load. For uncut fabric, open out tight folds and leave enough space for the length to move freely in the drum.

Choose a gentle cycle and check the spin setting separately. A machine may still select a fast final spin when you lower the temperature to 30°C. Measure the detergent for the size of the load and your local water hardness, using the guidance on the pack. If your sweatshirt comes out with visible detergent streaks, rinse it again before drying.

Air drying a length of fabric or a finished hoodie

Lift wet fleece with both hands to support its weight. Spread a cut length across several bars of a drying rack, with air space between folds. For a hoodie, ease the hem and cuffs back into shape and lay the garment across the rack. Open out the hood and turn thick sections partway through drying. Check the inside of the waistband, pockets and hood before folding the garment away; these can still be damp when the sleeves feel dry.

For this cutmyfabric fleece, air drying is preferable to tumble drying. If a seam needs pressing, test a steam iron on an offcut first. Apply steam lightly and avoid pressing the iron firmly into the fluffy surface. Let the test piece cool, then look at it from the side to see whether the pressure has left a flat patch.

Loose fluff or pilling?

A little loose fibre during the first two or three washes is common with new brushed fleece. Brushing raises fibres on the inside of the knit, and some may come away early on. You might notice a few chocolate brown fibres on a pale T-shirt, for example. This initial shedding usually settles with washing.

Pilling looks different. Small balls of tangled fibres stay attached to the surface, often under the arms or where a bag rubs against the hip. If you see them mainly in one place, look for what rubs there during wear. A hotter wash will not remove attached pills. Keeping abrasive items out of the wash helps limit further rubbing while the garment is in the drum.

Back to blog